[SOLVED] An Assembly File

Assembly – Course completion project1 “Completeness” in the existing Assembly programThe program in the project knows how to get a table of pointers for data blocks in Flash, outPtrs, RAM – array of 3), and respectively, a table of pointers for addresses in (inPtrs (array of 3).The program reads the address of the data from the table, and through it reaches the block of the data. Please note, all pointers are 11 bits.The data blocks are all 8 bytes long.It also reads the address in RAM where the final array will start, and from there the data will be copied from the block in the flash.The existing plan needs to be supplemented / corrected / renovated so that everything goes through assembly, and that the data does move in the correct order to the places defined in RAM.And through the routine you will encode (part 2) the maximum numbers in each block will be filled.Pay attention to the comments in the program – there is a full name information that will help you decipher what should be in the code !!| Page12 Routine writing findMaxNumAndSaveIt The input is the INDEX number of the same block of data (0, 1, or 2)The output is to update the MaxNum array which will be set to 0x90 within the RAM with the highest number in the data block.You must scan all the numbers in that block of data, and decide which number is the largest.And keep it in an array at the appropriate entry for the block number.For example: for block # 2 containing the numbers 2, 4, 1, 9, 9 will be written instead of the 2nd of the MaxNum array.